| ELECTRICAL ERROR ANGULAR RANGE IN MINUTES | -7.0 TO 7.0 |
| ACTUATOR FRICTION TORQUE AT MINUS 55 DEG CELSIUS | 0.04 INCH-OUNCES NOMINAL |
| BODY MATERIAL | ALUMINUM |
| BODY SIZE | 8 |
| BODY STYLE | STANDARD ROUND A |
| FLANGE DIAMETER | 0.7500 INCHES MAXIMUM |
| FLANGE THICKNESS | 0.0620 INCHES NOMINAL |
| FRAGILITY FACTOR | MODERATELY RUGGED |
| FREQUENCY IN HERTZ | 400.0 NOMINAL |
| OVERALL LENGTH | 1.7900 INCHES MAXIMUM |
| MAXIMUM FUNDAMENTAL NULL VOLTAGE IN MILLIVOLTS PER VOLT | 20.00 OUTPUT |
| MAXIMUM TEMP RISE | 8.5 CELSIUS |
| MAXIMUM TOTAL NULL VOLTAGE OUTPUT IN MILLIVOLTS PER VOLT | 30.00 |
| MOUNTING SURFACE TO TERMINAL END DISTANCE | 1.2400 INCHES MAXIMUM |
| PILOT DIAMETER | 0.5000 INCHES MAXIMUM |
| PHASE SHIFT ANGLE IN DEG | 8.500 INPUT TO OUTPUT NOMINAL |
| PILOT LENGTH | 0.0400 INCHES NOMINAL |
| ROTOR INPUT CURRENT RATING | 153.0 MILLIAMPERES NOMINAL |
| ROTOR INPUT ELECTRICAL POWER RATING | 70.0 MILLIWATTS NOMINAL |
| ROTOR INPUT VOLTAGE RATING IN VOLTS | 26.0 NOMINAL |
| SHAFT DIAMETER | 0.0900 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT LENGTH | 0.5000 INCHES NOMINAL SINGLE SHAFT |
| SHAFT SLOT DEPTH | 0.0250 INCHES NOMINAL SINGLE SHAFT |
| SHAFT SLOT WIDTH | 0.0200 INCHES NOMINAL SINGLE SHAFT |
| SHAFT TYPE | ROUND, SLOTTED SINGLE SHAFT |
| SPECIFICATION/STANDARD DATA | 81349-MIL-S-20708/78 GOVERNMENT SPECIFICATION |
| ZRO IMPEDANCE ANGLE IN DEG | 77.50 MINIMUM AND 80.50 MAXIMUM |
| ZRO IMPEDANCE MAGNITUDE IN OHMS | 170.00 MINIMUM AND 215.00 MAXIMUM |
| ZSS IMPEDANCE MAGNITUDE IN OHMS | 11.00 MINIMUM AND 15.00 MAXIMUM |
| ZSS IMPEDANCE ANGLE IN DEG | 9.00 MINIMUM AND 15.00 MAXIMUM |
| TERMINAL LOCATION | REAR |
| TERMINAL TYPE AND QUANTITY | 5 WIRE LEAD |
| TEST DATA DOCUMENT | 81349-MIL-S-20708 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| TRANSFORMATION RATIO | 0.454 ROTOR TO STATOR NOMINAL |
| UNDERCUT DIAMETER | 0.6870 INCHES NOMINAL |
| UNDERCUT WIDTH | 0.0620 INCHES NOMINAL |