| ELECTRICAL ERROR ANGULAR RANGE IN MINUTES | -18.0 TO 18.0 |
| ACTUATOR FRICTION TORQUE AT MINUS 55 DEG CELSIUS | 25.00 CENTIMETER-GRAMS MAXIMUM |
| ACTUATOR FRICTION TORQUE AT PLUS 25 DEG CELSIUS | 7.00 CENTIMETER-GRAMS MAXIMUM |
| BODY SIZE | 10 |
| BODY STYLE | STANDARD ROUND B |
| FLANGE DIAMETER | 0.9360 INCHES MINIMUM AND 0.9370 INCHES MAXIMUM |
| FLANGE THICKNESS | 0.0570 INCHES MINIMUM AND 0.0670 INCHES MAXIMUM |
| FREQUENCY IN HERTZ | 400.0 NOMINAL |
| OVERALL LENGTH | 1.6690 INCHES NOMINAL |
| MAXIMUM TOTAL NULL VOLTAGE OUTPUT IN MILLIVOLTS PER VOLT | 60.00 |
| MOUNTING SURFACE TO TERMINAL END DISTANCE | 1.1110 INCHES MINIMUM AND 1.1210 INCHES MAXIMUM |
| PILOT DIAMETER | 0.4995 INCHES MINIMUM AND 0.5000 INCHES MAXIMUM |
| PHASE SHIFT ANGLE IN DEG | 15.000 INPUT TO OUTPUT MINIMUM AND 19.000 INPUT TO OUTPUT MAXIMUM |
| PILOT LENGTH | 0.0330 INCHES MINIMUM AND 0.0430 INCHES MAXIMUM |
| ROTOR DC RESISTANCE IN OHMS | 200.00 NOMINAL |
| ROTOR INPUT CURRENT RATING | 55.0 MILLIAMPERES MAXIMUM |
| ROTOR INPUT ELECTRICAL POWER RATING | 60.0 MILLIWATTS MAXIMUM |
| ROTOR INPUT VOLTAGE RATING IN VOLTS | 26.0 NOMINAL |
| SHAFT END PLAY | 0.0003 INCHES MINIMUM AND 0.0015 INCHES MAXIMUM |
| SHAFT DIAMETER | 0.0895 INCHES MINIMUM AND 0.0900 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT MAXIMUM RADIAL PLAY | 0.0008 INCHES |
| SHAFT LENGTH | 0.3700 INCHES MINIMUM AND 0.3800 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT SLOT DEPTH | 0.0160 INCHES MINIMUM AND 0.0310 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT SLOT WIDTH | 0.0250 INCHES MINIMUM AND 0.0270 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT TYPE | ROUND, SLOTTED SINGLE SHAFT |
| SHOULDER DIAMETER | 0.8118 INCHES MINIMUM AND 0.8123 INCHES MAXIMUM |
| SHOULDER LENGTH | 0.0570 INCHES MINIMUM AND 0.0670 INCHES MAXIMUM |
| STATOR DC RESISTANCE IN OHMS | 42.00 NOMINAL |
| TERMINAL LOCATION | REAR |
| TERMINAL TYPE AND QUANTITY | 7 WIRE LEAD |
| TEST DATA DOCUMENT | 56232-714056-2 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
| TRANSFORMATION RATIO | 0.440 STATOR TO ROTOR MINIMUM AND 0.468 STATOR TO ROTOR MAXIMUM |
| UNDERCUT WIDTH | 0.0570 INCHES MINIMUM AND 0.0670 INCHES MAXIMUM |