| AFT OF FIRST FLANGE DIAMETER | 1.9940 INCHES MINIMUM AND 1.9950 INCHES MAXIMUM |
| ALIGNMENT HOLE QUANTITY | 4 |
| BODY DIAMETER | 1.9840 INCHES NOMINAL |
| BODY MATERIAL | ALUMINUM ALLOY |
| BODY SIZE | 23 |
| BODY STYLE | STANDARD ROUND D |
| FLANGE DIAMETER | 2.2490 INCHES MINIMUM AND 2.2500 INCHES MAXIMUM |
| FLANGE THICKNESS | 0.2480 INCHES MINIMUM AND 0.2500 INCHES MAXIMUM |
| FREQUENCY IN HERTZ | 400.0 NOMINAL |
| OVERALL LENGTH | 4.7430 INCHES MINIMUM AND 4.7990 INCHES MAXIMUM |
| MAXIMUM FUNDAMENTAL NULL VOLTAGE IN MILLIVOLTS PER VOLT | 20.00 OUTPUT |
| MAXIMUM TOTAL NULL VOLTAGE OUTPUT IN MILLIVOLTS PER VOLT | 30.00 |
| MOUNTING SURFACE TO TERMINAL END DISTANCE | 4.0240 INCHES MINIMUM AND 4.0800 INCHES MAXIMUM |
| SHOULDER LENGTH | 0.1680 INCHES MINIMUM AND 0.1700 INCHES MAXIMUM |
| PHASE SHIFT ANGLE IN DEG | 0.900 INPUT TO OUTPUT NOMINAL |
| PILOT LENGTH | 0.0310 INCHES MINIMUM AND 0.0430 INCHES MAXIMUM |
| PILOT DIAMETER | 0.5900 INCHES MINIMUM AND 0.6000 INCHES MAXIMUM |
| SECOND SHOULDER DIAMETER | 1.9985 INCHES MINIMUM AND 1.9995 INCHES MAXIMUM |
| SECOND SHOULDER LENGTH | 0.1680 INCHES MINIMUM AND 0.1700 INCHES MAXIMUM |
| SHAFT DIAMETER | 0.2402 INCHES MINIMUM AND 0.2405 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT NOMINAL THREAD SIZE | 0.250 INCHES SINGLE SHAFT |
| SHAFT THREAD CLASS | 3A SINGLE SHAFT |
| SHAFT THREAD DIRECTION | RIGHT-HAND SINGLE SHAFT |
| SHAFT LENGTH | 0.6930 INCHES MINIMUM AND 0.7190 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT THREAD LENGTH | 0.2800 INCHES MINIMUM AND 0.3100 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT THREAD SERIES DESIGNATOR | UNF SINGLE SHAFT |
| SHAFT TYPE | ROUND, THREADED SINGLE SHAFT |
| SHOULDER DIAMETER | 1.9850 INCHES MINIMUM AND 1.9950 INCHES MAXIMUM |
| STATOR INPUT VOLTAGE RATING IN VOLTS | 90.0 NOMINAL |
| STATOR INPUT CURRENT RATING | 23.0 MILLIAMPERES NOMINAL |
| STATOR INPUT ELECTRICAL POWER RATING | 100.0 MILLIWATTS NOMINAL |
| TERMINAL LOCATION | REAR |
| TERMINAL TYPE AND QUANTITY | 8 SCREW |
| TEST DATA DOCUMENT | 18876-9144188 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
| TRANSFORMATION RATIO | 1.000 ROTOR TO STATOR NOMINAL |