| CONTACT LOAD CURRENT RATING | 1.0 AMPERES RESISTIVE LOAD AC AT SEA LEVEL |
| CONTACT LOAD CURRENT RATING | 2.0 AMPERES RESISTIVE LOAD DC AT SEA LEVEL |
| CONTACT SWITCHING ACTION | BREAKS BEFORE MAKES EACH SECTION FRONT |
| CONTACT VOLTAGE RATING IN VOLTS | 110.0 AC AT SEA LEVEL |
| CONTACT VOLTAGE RATING IN VOLTS | 28.0 DC AT SEA LEVEL |
| FIRST FLAT LENGTH | 0.370 INCHES MINIMUM AND 0.380 INCHES MAXIMUM SINGLE ACTUATOR |
| FLAT HEIGHT | 0.214 INCHES MINIMUM AND 0.218 INCHES MAXIMUM SINGLE ACTUATOR |
| INDIVIDUAL SECTION QUANTITY | 2 |
| OPERATING TEMP RANGE | -65.0 TO 85.0 CELSIUS |
| OVERALL HEIGHT | 1.516 INCHES MINIMUM AND 1.546 INCHES MAXIMUM |
| OVERALL LENGTH | 2.540 INCHES MAXIMUM |
| OVERALL WIDTH | 1.296 INCHES MINIMUM AND 1.328 INCHES MAXIMUM |
| MOUNTING METHOD | THREADED BUSHING W/PANEL SEAL SINGLE MOUNTING FACILITY |
| NOMINAL THREAD SIZE | 0.375 INCHES SINGLE MOUNTING FACILITY |
| NONTURN DEVICE RADIUS | 0.531 INCHES NOMINAL AT 3:00 O'CLOCK |
| NONTURN DEVICE TYPE | TAB AT 3:00 O'CLOCK |
| POLE QUANTITY | 1 EACH SECTION REAR |
| ROTOR THROUGH CONNECTION QUANTITY | 1 EACH SECTION |
| SHAFT FLAT/SLOT ANGULAR LOCATION | 192.8 DEGREES FROM NONTURN DEVICE SINGLE ACTUATOR |
| SHAFT DIAMETER | 0.247 INCHES MINIMUM AND 0.250 INCHES MAXIMUM SINGLE ACTUATOR |
| SHAFT TYPE | ROUND, FLATTED SINGLE ACTUATOR |
| SHAFT LENGTH | 0.828 INCHES MINIMUM AND 0.858 INCHES MAXIMUM SINGLE ACTUATOR |
| STYLE DESIGNATOR | CIRCULAR WAFER, BUSHING MOUNT |
| SWITCH ACTUATOR INDEXING POSITION QUANTITY | 14 SINGLE ACTUATOR |
| SWITCH ACTUATOR POSITIONING INCREMENT | 25.7 DEGREES SINGLE ACTUATOR |
| SWITCH CONTACT BASIC DESIGN | NONPILE-UP SYMMETRICAL |
| TERMINAL TYPE | TAB, SOLDER LUG |
| TEST DATA DOCUMENT | 81349-MIL-S-3786 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| THREAD LENGTH | 0.370 INCHES MINIMUM AND 0.380 INCHES MAXIMUM SINGLE MOUNTING FACILITY |
| THREAD SERIES DESIGNATOR | UNEF SINGLE MOUNTING FACILITY |
| THROW QUANTITY | 14 EACH SECTION FRONT |