| EFFECTIVE ELECTRICAL ROTATION IN DEG ANGULAR ROTATION | 7200.0 MINIMUM AND 16200.0 MAXIMUM |
| ELECTRICAL RESISTANCE PER SECTION | 500.000 OHMS SINGLE SECTION |
| ACTUATOR TRAVEL CONTROL FEATURE | STOPS |
| ACTUATOR TYPE | SINGLE SHAFT |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 85.0 SINGLE SECTION |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | 150.0 SINGLE SECTION |
| BODY HEIGHT | 0.490 INCHES MINIMUM AND 0.510 INCHES MAXIMUM |
| BODY LENGTH | 0.490 INCHES MINIMUM AND 0.510 INCHES MAXIMUM |
| BODY STYLE | RECTANGULAR W/MOUNTING HOLES |
| BODY WIDTH | 0.182 INCHES MINIMUM AND 0.197 INCHES MAXIMUM |
| CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL | 0.300 INCHES NOMINAL |
| CENTER TO CENTER DISTANCE BETWEEN TERMINALS | 0.600 INCHES NOMINAL |
| CONTACT ARM ELECTRICAL OFF POSITION | FULLY CW |
| LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS | 0.513 INCHES MINIMUM AND 0.526 INCHES MAXIMUM |
| OVERALL HEIGHT | 0.490 INCHES MINIMUM AND 0.510 INCHES MAXIMUM |
| OVERALL LENGTH | 0.515 INCHES MINIMUM AND 0.555 INCHES MAXIMUM |
| OVERALL WIDTH | 0.182 INCHES MINIMUM AND 0.197 INCHES MAXIMUM |
| MAXIMUM STARTING TORQUE | 8.00 INCH-OUNCES |
| MOUNTING FACILITY QUANTITY | 2 |
| MOUNTING HOLE DIAMETER | 0.090 INCHES MINIMUM AND 0.098 INCHES MAXIMUM |
| MOUNTING METHOD | UNTHREADED HOLE |
| POWER DISSIPATION RATING PER SECTION IN WATTS | 0.8 FREE AIR SINGLE SECTION |
| RELIABILITY INDICATOR | NOT ESTABLISHED |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -5.0 TO 5.0 SINGLE SECTION |
| ROTARY ACTUATOR TRAVEL IN ANGULAR DEG | 7200.0 MINIMUM AND 16200.0 MAXIMUM |
| SECTION QUANTITY | 1 |
| SHAFT DIAMETER | 0.058 INCHES MINIMUM AND 0.098 INCHES MAXIMUM |
| SHAFT LENGTH | 0.025 INCHES MINIMUM AND 0.045 INCHES MAXIMUM |
| SHAFT STYLE | ROUND, SLOTTED |
| SPECIFICATION/STANDARD DATA | 81349-MIL-R-27208/2 GOVERNMENT SPECIFICATION |
| TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS | -50.0 TO 50.0 SINGLE SECTION |
| TERMINAL LENGTH | 6.000 INCHES MINIMUM |
| TERMINAL LOCATION | REAR END |
| TERMINAL TYPE AND QUANTITY | 3 PIN |
| TEST DATA DOCUMENT | 81349-MIL-R-27208 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |