|
|
|
National Stock Number:
5905-00-137-4030
Federal Supply Class:
5905
National Item Identification Number:
001374030
Description:
RESISTOR,FIXED,WIRE WOUND
Detail:
INC 37403 REINSTATED ON 010303~A resistor whose ohmic value cannot be adjusted or varied. The resistance element consists of high resistance wire (or ribbon) either wound on an insulated form or constructed so as to be self-supporting. The item must have inherent characteristics of inducing self-inductance. Opposition to current flow is an inherent property of the resistance wire and is manifested by the heat dissipation in the resistor. Excludes SUPPRESSOR, IGNITION INTERFERENCE. See also RESISTOR (1), FIXED, WIRE WOUND, NONINDUCTIVE.
|
Manufacturer Information:
| 1460-001 | 05347 | ULTRONIX INC | | 443-1586-001 | 94756 | THE BOEING COMPANY | | EGS-1-1 1 0HM 1PCT | 91637 | VISHAY DALE ELECTRONICS, LLC | | EGS-1-1 1 OHM 1PCT | 91637 | VISHAY DALE ELECTRONICS, LLC | | EGS1-001 | 91637 | VISHAY DALE ELECTRONICS, LLC | | SA02-001 | 53655 | AVOX SYSTEMS INC |
|
Techincal Specification:
| ELECTRICAL RESISTANCE | 1.000 OHMS | | AMBIENT TEMP AT FULL RATED POWER | 25.0 CELSIUS | | AMBIENT TEMP IN DEG CELSIUS AT ZERO PERCENT RATED POWER | 275.0 | | BODY DIAMETER | 0.065 INCHES MINIMUM AND 0.105 INCHES MAXIMUM | | BODY LENGTH | 0.219 INCHES MINIMUM AND 0.281 INCHES MAXIMUM | | CUBIC MEASURE | 0.002 CUBIC INCHES | | INCLOSURE TYPE | ENCAPSULATED | | POWER DISSIPATION RATING IN WATTS | 1.000 FREE AIR | | RELIABILITY INDICATOR | ESTABLISHED | | RELIABILITY FAILURE RATE LEVEL IN PERCENT | 1.000 | | RESISTANCE TOLERANCE IN PERCENT | -1.000 TO 1.000 | | STYLE DESIGNATOR | AXIAL TERMINAL EACH END | | TEMP COEFFICIENT OF RESISTANCE IN PPM PER DEG CELSIUS | -50.0 TO 50.0 | | TEMP RANGE OF TEMP COEFFICIENT IN DEG CELSIUS | -55.0 TO 275.0 | | TERMINAL LENGTH | 1.500 INCHES MINIMUM | | TERMINAL TYPE | WIRE LEAD | | TEST DATA DOCUMENT | 94756-443-1586 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
|
|