8140-01-266-2177 SHIPPING AND STORAGE CONTAINER,G Index 5935-01-266-2179 CONNECTOR,PLUG,ELECTRICAL

National Stock Number:
5365-01-266-2178

Federal Supply Class:
5365

National Item Identification Number:
012662178

Description:
SPACER,PLATE

Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.


Manufacturer Information:
8742741-0198747OGDEN AIR LOGISTICS CENTER


Techincal Specification:
BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE0.313 INCHES NOMINAL
BOLT HOLE QUANTITY2
CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH0.750 INCHES NOMINAL
HOLE DIAMETER0.154 INCHES MINIMUM AND 0.158 INCHES MAXIMUM
OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH0.190 INCHES NOMINAL
OVERALL LENGTH1.130 INCHES MINIMUM AND 1.140 INCHES MAXIMUM
OVERALL WIDTH0.610 INCHES MINIMUM AND 0.625 INCHES MAXIMUM
MATERIAL DOCUMENT AND CLASSIFICATIONMIL-S-5059,TYPE 304 MIL SPEC SINGLE MATERIAL RESPONSE
MATERIALSTEEL COMP 304
SPECIAL FEATURESHOLES COUNTERSUNK 0.290 IN MIN,0.295 IN MAX BY 100 DEGREES; ONE LENGTHEDGE CHAMPHERED 45 DEGREES BY 0.060
STYLE DESIGNATORNON-CIRCULAR W/SQUARE CORNERS
SURFACE TREATMENT DOCUMENT AND CLASSIFICATIONQQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE
SURFACE TREATMENTPASSIVATE


Click here to Register for Free 30-day Trial