|
|
|
National Stock Number:
5365-01-211-3737
Federal Supply Class:
5365
National Item Identification Number:
012113737
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 8298424 | 19200 | US ARMY ARDEC RDECOM |
|
Techincal Specification:
| BOLT HOLE QUANTITY | 2 | | BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE | 0.188 INCHES NOMINAL | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 0.687 INCHES NOMINAL | | END RADIUS | 0.187 INCHES NOMINAL | | HARDNESS RATING | 30.0 ROCKWELL C MINIMUM AND 35.0 ROCKWELL C MAXIMUM | | HOLE DIAMETER | 0.177 INCHES NOMINAL | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.187 INCHES NOMINAL | | OVERALL LENGTH | 2.050 INCHES NOMINAL | | OVERALL WIDTH | 0.375 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | QQ-S-766 COND A FED SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL COMP 410 | | SPECIAL FEATURES | 2 HOLES ARE COUNTERSUNK 82 DEGREES TO A DIA OF 0.332 INCH | | STYLE DESIGNATOR | NON-CIRCULAR W/ROUNDED ENDS | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE | | SURFACE TREATMENT | PASSIVATE |
|
|