|
|
|
National Stock Number:
5365-01-060-3794
Federal Supply Class:
5365
National Item Identification Number:
010603794
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 532R616H01 | 97942 | NORTHROP GRUMMAN SYSTEMS CORPORATION |
|
Techincal Specification:
| BOLT HOLE QUANTITY | 2 | | BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE | 0.250 INCHES NOMINAL | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 0.520 INCHES NOMINAL | | HOLE DIAMETER | 0.170 INCHES MINIMUM AND 0.175 INCHES MAXIMUM | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.240 INCHES NOMINAL | | OVERALL LENGTH | 1.000 INCHES NOMINAL | | OVERALL WIDTH | 0.500 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | QQ-A-225/8 FED SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | ALUMINUM ALLOY 6061 | | SPECIAL FEATURES | HAS TWO THICKNESSES,ONE-HALF OF THE LENGTH HAS A THICKNESS OF 0.250 IN. AND THE OTHER IS 0.080 IN.. THE HOLE IN THE THICKER SECTION HAS A COUNTERSINK,100.0 DEG PORM 5.0 DEG TO A DIA OF 0.225 IN. ON THE FLAT SIDE | | STYLE DESIGNATOR | NON-CIRCULAR W/SQUARE CORNERS | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | MIL-C-5541 MIL SPEC SINGLE TREATMENT RESPONSE | | SURFACE TREATMENT | CHROMATE |
|
|