|
|
|
National Stock Number:
5365-01-033-9389
Federal Supply Class:
5365
National Item Identification Number:
010339389
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 12255117 | 19207 | U S ARMY TANK AUTOMOTIVE COMMAND AMSTA-IM-MM |
|
Techincal Specification:
| BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE | 0.310 INCHES NOMINAL | | BOLT HOLE QUANTITY | 2 | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 1.219 INCHES NOMINAL | | HOLE DIAMETER | 0.327 INCHES MINIMUM AND 0.345 INCHES MAXIMUM | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.330 INCHES NOMINAL | | OVERALL LENGTH | 1.880 INCHES NOMINAL | | OVERALL WIDTH | 0.620 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | QQ-S-741 FED SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL | | STYLE DESIGNATOR | NON-CIRCULAR W/SQUARE CORNERS | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | TT-P-636 FED SPEC 1ST TREATMENT RESPONSE AND TT-E-529 FED SPEC 2ND TREATMENT RESPONSE | | SURFACE TREATMENT | PRIMER OR ENAMEL SEMIGLOSS |
|
|