|
|
|
National Stock Number:
5365-01-019-2993
Federal Supply Class:
5365
National Item Identification Number:
010192993
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 120462-3 | 94271 | LOCKHEED MARTIN CORP |
|
Techincal Specification:
| BOLT HOLE CENTERLINE TO NEAREST EDGE DISTANCE | 0.188 INCHES NOMINAL | | BOLT HOLE QUANTITY | 5 | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 3.615 INCHES MINIMUM AND 3.635 INCHES MAXIMUM | | HOLE DIAMETER | 0.250 INCHES NOMINAL | | OUTSIDE EDGE TO BOLT HOLE CENTER DISTANCE ALONG LENGTH | 0.312 INCHES NOMINAL | | OVERALL LENGTH | 15.125 INCHES NOMINAL | | OVERALL WIDTH | 0.375 INCHES NOMINAL | | MATERIAL | STEEL COMP 301 | | REFERENCE NUMBER DIFFERENTIATING CHARACTERISTICS | AS DIFFERENTIATED BY MATERIAL WHICH MUST CONFORM TO SHIPS PARTS CONTROL CENTER SPECIAL QUALITY CONTROL PROVISIONS | | SPECIAL TEST FEATURES | SPECIAL QUALITY CONTROL TESTING | | STYLE DESIGNATOR | NON-CIRCULAR W/SQUARE CORNERS | | SURFACE TREATMENT | PASSIVATE | | TEST DATA DOCUMENT | 81349-MIL-P-23199 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
|
|