|
|
|
National Stock Number:
5365-01-019-2990
Federal Supply Class:
5365
National Item Identification Number:
010192990
Description:
SHIM
Detail:
A thin flat metal or plastic item of various peripheral shapes having a solid or laminated cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole and having a solid rectangular cross-section use DISK, SOLID, PLAIN. Items with either (1) a solid (not laminated) cross-section, or (2) a non-separable laminated cross-section with one hole centrally located, must have a thickness less than 0.006 inch (0.152 mm) for items less than 1/4 inch (6.35 mm) outside diameter or shortest distance across peripheral flats, and less than 0.016 inch (0.406 mm) for items 1/4 inch (6.35 mm) or more outside diameter, or shortest distance across peripheral flats. For items with thickness greater than those indicated above, see SPACER, PLATE; WASHER, FLAT and SPACER, RING. When thickness and/or outside diameter or shortest distance across peripheral flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance. See also SHIM STOCK, LAMINATED; SHIM STOCK ASSORTMENT, GASKET; and BEARING, WASHER, THRUST.
|
Manufacturer Information:
| 120462-1 | 94271 | LOCKHEED MARTIN CORP |
|
Techincal Specification:
| BOLT HOLE QUANTITY | 5 | | CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH | 3.615 INCHES MINIMUM AND 3.635 INCHES MAXIMUM | | OVERALL LENGTH | 15.125 INCHES NOMINAL | | OVERALL THICKNESS | 0.010 INCHES NOMINAL | | OVERALL WIDTH | 0.375 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | AISI 301 ASSN STD SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL | | REFERENCE NUMBER DIFFERENTIATING CHARACTERISTICS | AS DIFFERENTIATED BY MATERIAL WHICH MUST CONFORM TO SHIPS PARTS CONTROL CENTER SPECIAL QUALITY CONTROL PROVISIONS | | SPECIAL TEST FEATURES | SPECIAL QUALITY CONTROL TESTING | | SURFACE TREATMENT | PASSIVATE | | TEST DATA DOCUMENT | 81349-MIL-P-23199 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
|
|