5365-01-015-6170 SHIM Index 5365-01-015-6175 SPACER,PLATE

National Stock Number:
5365-01-015-6174

Federal Supply Class:
5365

National Item Identification Number:
010156174

Description:
SPACER,PLATE

Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.


Manufacturer Information:
3370C04-H0104804NORTHROP GRUMMAN SYSTEMS CORPORATION
3370C04-H0154372RIDGE ENGINEERING, LLC.
RO010613873DLA AVIATION


Techincal Specification:
BOLT HOLE QUANTITY2
CENTER TO CENTER DISTANCE BETWEEN BOLT HOLES ALONG LENGTH1.500 INCHES NOMINAL
HOLE DIAMETER0.934 INCHES MINIMUM AND 0.944 INCHES MAXIMUM
OVERALL LENGTH3.500 INCHES NOMINAL
OVERALL WIDTH2.250 INCHES NOMINAL
MATERIAL DOCUMENT AND CLASSIFICATIONQQ-S-698 FED SPEC SINGLE MATERIAL RESPONSE
MATERIALSTEEL
SPECIAL TEST FEATURESSPECIAL QUALITY CONTROL TESTING
STYLE DESIGNATORNON-CIRCULAR W/SQUARE CORNERS
SURFACE TREATMENT DOCUMENT AND CLASSIFICATIONQQ-P-416,TY 2,CL 1 FED SPEC SINGLE TREATMENT RESPONSE
TEST DATA DOCUMENT81349-MIL-P-23199 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.).


Click here to Register for Free 30-day Trial