|
|
|
National Stock Number:
5310-01-016-4871
Federal Supply Class:
5310
National Item Identification Number:
010164871
Description:
WASHER,FLAT
Detail:
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
|
Manufacturer Information:
| 395-0185 | 25500 | LOCKHEED MARTIN CORPORATION | | 5310PL0554931 | 9009H | INSPEKTORAT WSPARCIA SIL ZBROJNYCH | | 6057018 | D9182 | ZF INDUSTRIEANTRIEBE WITTEN GMBH | | AN 960-616 | D9182 | ZF INDUSTRIEANTRIEBE WITTEN GMBH | | AN960-616 | 88044 | AERONAUTICAL STANDARDS GROUP DEPT OF NAVY AND AIR FORCE |
|
Techincal Specification:
| CENTER HOLE SHAPE STYLE | ROUND | | CROSS-SECTIONAL SHAPE STYLE | RECTANGULAR | | HOLE DIAMETER | 0.380 INCHES MINIMUM AND 0.400 INCHES MAXIMUM | | OVERALL DIAMETER | 0.620 INCHES MINIMUM AND 0.645 INCHES MAXIMUM | | MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-7952 MIL SPEC SINGLE MATERIAL RESPONSE OR QQ-S-698,COND CR,TEMPER 1 FED SPEC SINGLE MATERIAL RESPONSE OR QQ-S-698,COND CR,TEMPER 2 FED SPEC SINGLE MATERIAL RESPONSE OVERALL | | MATERIAL | STEEL OVERALL | | PERIPHERAL SHAPE STYLE | ROUND | | SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TY 2,CL 3 FED SPEC SINGLE TREATMENT RESPONSE OVERALL | | SURFACE TREATMENT | CADMIUM OVERALL | | TEST DATA DOCUMENT | 81349-MIL-P-23199 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). | | THICKNESS | 0.053 INCHES MINIMUM AND 0.073 INCHES MAXIMUM |
|
|