5950-00-810-8335 TRANSFORMER,POWER Index 5985-00-810-8340 SEAL,WAVEGUIDE

National Stock Number:
5310-00-810-8336

Federal Supply Class:
5310

National Item Identification Number:
008108336

Description:
WASHER,FLAT

Detail:
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.


Manufacturer Information:
10334324617GENERAL MOTORS CORP
10334372582ROLLS-ROYCE SOLUTIONS AMERICA INC
1033437X677GENERAL MOTORS LLC
23MS15795-1880045L3HARRIS CINCINNATI ELECTRONICS CORPORATION
G43W7855-22599993DEPARTMENT OF THE NAVY
MS15795-1880205NATIONAL AEROSPACE STANDARDS COMMITTEE AEROSPACE INDUSTRIES ASSOCIATION OF AMERICA INC NOT FOR RFQ OR SOLICITATION USE
MS15795-1896906MILITARY STANDARDS PROMULGATED BY MILITARY DEPARTMENTS UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M
PC103343C7432POWER COMPONENTS (DEUTSCHLAND) GMBH


Techincal Specification:
CENTER HOLE SHAPE STYLEROUND
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HEAT TREATMENTAS FABRICATED
HOLE DIAMETER0.531 INCHES NOMINAL
OVERALL DIAMETER1.062 INCHES NOMINAL
MATERIAL DOCUMENT AND CLASSIFICATIONQQ-S-763 FED SPEC ALL MATERIAL RESPONSES OVERALL
MATERIALSTEEL COMP 302 OR STEEL COMP 303 OR STEEL COMP 304 OR STEEL COMP 305 OR STEEL COMP 310 OR STEEL COMP 316 OVERALL
PERIPHERAL SHAPE STYLEROUND
SURFACE TREATMENT DOCUMENT AND CLASSIFICATIONQQ-P-35 FED SPEC SINGLE TREATMENT RESPONSE OVERALL
SURFACE TREATMENTPASSIVATE OVERALL
THICKNESS0.074 INCHES MINIMUM AND 0.121 INCHES MAXIMUM


Click here to Register for Free 30-day Trial