| BORE CENTER TO SHANK END DISTANCE | 1.9280 INCHES MINIMUM AND 1.9480 INCHES MAXIMUM |
| BORE DIAMETER | 0.3745 INCHES MINIMUM AND 0.3750 INCHES MAXIMUM |
| HARDNESS RATING | 55.0 ROCKWELL C MINIMUM AND 62.0 ROCKWELL C MAXIMUM INNER MEMBER |
| HARDNESS RATING | 23.0 ROCKWELL C MINIMUM AND 35.0 ROCKWELL C MAXIMUM RACE INSERT |
| HARDNESS RATING | 39.0 ROCKWELL C MINIMUM AND 42.0 ROCKWELL C MAXIMUM ROD END BODY |
| INNER MEMBER WIDTH | 0.5000 INCHES NOMINAL |
| OUTER MEMBER WIDTH | 0.4110 INCHES MINIMUM AND 0.4210 INCHES MAXIMUM |
| OUTER MEMBER OUTSIDE DIAMETER | 1.0150 INCHES MINIMUM AND 1.0350 INCHES MAXIMUM |
| OVERALL LENGTH | 2.4505 INCHES NOMINAL |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 5630 ASSN STD SINGLE MATERIAL RESPONSE INNER MEMBER |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 5643 ASSN STD 1ST MATERIAL RESPONSE OR AMS 5659 ASSN STD 2ND MATERIAL RESPONSE RACE INSERT |
| MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-5000 MIL SPEC SINGLE MATERIAL RESPONSE ROD END BODY |
| MATERIAL | PLASTIC TETRAFLUOROETHYLENE RACE LINER |
| MATERIAL | STEEL COMP 630 OR STEEL COMP XM-12 RACE INSERT |
| MATERIAL | STEEL COMP 4340 ROD END BODY |
| MATERIAL | STEEL COMP 440C INNER MEMBER |
| SHANK STYLE | EXTERNALLY THREADED |
| SHANK THREAD LENGTH | 1.1560 INCHES MINIMUM AND 1.2180 INCHES MAXIMUM |
| SPECIFICATION/STANDARD DATA | 43999-LD131-0023 MANUFACTURERS STANDARD |
| STATIC RADIAL LOAD RATING | 8550 POUNDS |
| SPECIAL FEATURES | SEAL,ELASTOMERIC,RETAINED BY METAL RING OR INTEGRAL PART OF OUTER RACE ON EACH SIDE OF BEARING; 5.0 DEG MISALIGNMENT EACH SIDE |
| STYLE DESIGNATOR | BALL TYPE |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TYPE 1,CLASS 2 FED SPEC SINGLE TREATMENT RESPONSE ROD END BODY |
| SURFACE TREATMENT | CADMIUM ROD END BODY |
| TEST DATA DOCUMENT | 81349-MIL-I-6868 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| THREAD CLASS | 3A |
| THREAD DIAMETER | 0.3750 INCHES NOMINAL |
| THREAD DIRECTION | RIGHT-HAND |
| THREAD SERIES DESIGNATOR | UNJF |
| THREAD QUANTITY PER INCH | 24 |