6145-00-808-7430 WIRE,ELECTRICAL Index 4820-00-808-7442 VALVE,DIAPHRAGM,STOP

National Stock Number:
3040-00-808-7441

Federal Supply Class:
3040

National Item Identification Number:
008087441

Description:
SHAFT,SHOULDERED

Detail:
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (AA), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see AXLE(1), SHOULDERED. For items not having any of the above conditions see PIN, SHOULDER, HEADLESS. Excludes SHAFT(1), STRAIGHT; and AXLE(1), STRAIGHT.


Manufacturer Information:
1162114519207U S ARMY TANK AUTOMOTIVE COMMAND AMSTA-IM-MM
3040008087441SCY13E.C.A ETABLISSEMENT CENTRALD'APPROVISIONNEMENT DES FORCES ARMEE
388Q110978500MERITOR HEAVY VEHICLE SYSTEMS, LLC


Techincal Specification:
END SIMILARITYNOT IDENTICAL
FIRST END DIAMETER1.7719 INCHES NOMINAL
FIRST END SPLINE LENGTH0.969 INCHES NOMINAL
FIRST END SPLINE MAJOR DIAMETER1.7719 INCHES NOMINAL
FIRST END SPLINE MINOR DIAMETER1.4830 INCHES NOMINAL
FIRST END SPLINE QUANTITY17
FIRST END STYLESPLINED (STRAIGHT)
LARGEST STEP DIAMETER2.994 INCHES NOMINAL
OVERALL LENGTH14.563 INCHES NOMINAL
MATERIAL DOCUMENT AND CLASSIFICATIONQQ-S-624 FED SPEC SINGLE MATERIAL RESPONSE
MATERIALSTEEL COMP 4620H OR STEEL COMP 8620H
SECOND END EXTERNAL THREAD LENGTH0.813 INCHES NOMINAL
SECOND END HOLE DEPTH1.000 INCHES NOMINAL
SECOND END HOLE DIAMETER0.1563 INCHES NOMINAL
SECOND END DIAMETER1.0000 INCHES NOMINAL
SECOND END DISTANCE FROM HOLE CENTER TO END0.344 INCHES NOMINAL
SECOND END STYLECROSS DRILLED AND EXTERNALLY THREADED
SPECIAL FEATURESCENTER SPLINED 2.994 IN. MAJOR DIA,2.520 IN. MINOR DIA,20 DEG PRESSURE ANGLE,17 TEETH;2NT END HAS SECOND HOLE SAME AS STYLE AT 90 DEG TO 1ST HOLE
STEP QUANTITY6
SURFACE FINISH350.0 MICROINCHES


Click here to Register for Free 30-day Trial